/dev/hda:

 Model=PhatNoise DMS 10GB, FwRev=U1.14 F, SerialNo=52D92359T
 Config={ Fixed }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=46
 BuffType=unknown, BuffSize=0kB, MaxMultSect=16, MultSect=16
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=19640880
 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4 
 DMA modes:  sdma0 sdma1 sdma2 mdma0 mdma1 mdma2 
 UDMA modes: udma0 udma1 udma2 udma3 *udma4 
 AdvancedPM=yes: unknown setting WriteCache=disabled
 Drive conforms to: device does not report version: 

 * signifies the current active mode


ATA device, with non-removable media
	Model Number:       PhatNoise DMS 10GB                      
	Serial Number:      52D92359T           
	Firmware Revision:  U1.14 F 
Standards:
	Supported: 5 4 3 2 
	Likely used: 6
Configuration:
	Logical		max	current
	cylinders	16383	16383
	heads		16	16
	sectors/track	63	63
	--
	CHS current addressable sectors:   16514064
	LBA    user addressable sectors:   19640880
	device size with M = 1024*1024:        9590 MBytes
	device size with M = 1000*1000:       10056 MBytes (10 GB)
Capabilities:
	LBA, IORDY(can be disabled)
	bytes avail on r/w long: 46	Queue depth: 1
	Standby timer values: spec'd by Vendor, with device specific minimum
	R/W multiple sector transfer: Max = 16	Current = 16
	Advanced power management level: unknown setting (0x0080)
	DMA: sdma0 sdma1 sdma2 mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 *udma4 
	     Cycle time: min=120ns recommended=120ns
	PIO: pio0 pio1 pio2 pio3 pio4 
	     Cycle time: no flow control=120ns  IORDY flow control=120ns
Commands/features:
	Enabled	Supported:
	   *	NOP cmd
	   *	READ BUFFER cmd
	   *	WRITE BUFFER cmd
	   *	Host Protected Area feature set
	   *	Look-ahead
		Write cache
	   *	Power Management feature set
		Security Mode feature set
	   *	SMART feature set
		SET MAX security extension
	   *	Advanced Power Management feature set
Security: 
	Master password revision code = 65534
		supported
	not	enabled
	not	locked
		frozen
	not	expired: security count
	not	supported: enhanced erase
	16min for SECURITY ERASE UNIT. 
HW reset results:
	CBLID- above Vih
	Device num = 0 determined by the jumper
Checksum: correct